Your satisfaction with your Pella windows and doors is our highest priority. Should you have a problem with your Pella product that you suspect may be related to the window’s installation, trying the following steps can help determine if the product is installed level, square and plumb.
First, get a level and set it on the frame of the product, across the bottom or sill. Do not put it on the sashes or panels of the product as it could give an inaccurate reading. The bubble of your level should fall in the center, indicating the product is installed level.
Next, examine plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To test for plumb, put your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. Next, you’ll check for plumb from left to right by placing the level on each of the two sides. The bubble should fall in the midpoint on both sides, signifying the product is installed plumb.
After checking plumb, you can check for bowing by measuring the unit horizontally across the top, middle and bottom. The three measurements should all be equal, allowing 1/8 inch of leeway. It’s crucial to always measure to and from the same point on both sides for consistency. Finally, find out if your window or door is square by measuring from corner to corner in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other to indicate the product is
You can also examine the reveal, where the sash meets the frame. The gap should look the same from top to bottom and left to right. Every side of your product should appear the same, indicating the product is installed level, square, and plumb.
Taking the time to do a little troubleshooting on your own can provide helpful information to solve a problem. If you find that you have found one, or even a couple, of these issues, visit the Pella Window and Door Showroom in Mt. Pleasant or give us a call at 989-317-2558.